Blackberry 1902G Betriebsanweisung PDF herunterladen (Seite 115)

4 - 17

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before

the picture is taken. Use these codes to set the time between when the trigger

is pulled and when the picture is taken. During the delay time, the aiming light

will appear, but the LEDs won’t turn on until the delay time is over.

Default =

Off.

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the bar

code below, then set the time-out by scanning digits (0 - 4,000 ms) from the

Programming Chart inside the back cover of this manual, then scan Save.

Scanner Time-Out

Note: Scanner Time-Out applies only to corded scanners. It does not apply to

cordless systems.

Scanner Time-Out powers down the scanner after the unit has been idle for the

specified time. To prevent the scanner from powering down, set this time-out to

0. Scan Scanner Time-Out, then set the time-out by scanning digits (from 0 -

999,999 ms) from the inside back cover, then scanning Save.

Default = 1 ms.

400 milliseconds

* Off

(no delay)

200 milliseconds

Delay Duration

Scanner Time-Out

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 313 314

Keine Kommentare

Blackberry 1902G Betriebsanweisung Seite 115